Pallet Jack Hydraulic Unit Inspection Tips

Inspect the outside of the pallet jack hydraulic pump for oil leaks. Test the hydraulic unit under a load to determine if there is a problem. 

This can be done by lifting a heavy pallet and letting it stand for 15-20 minutes.

Trouble shooting tips for possible problems with your hydraulic unit:

Jack fails to lift load:

1. Air lock inside pump - place the control lever into release position, then pump the handle rapidly about 10-15 times.
2. Low fluid level - with the jack lowered, remove filler plug. Fill the reservoir until the oil is level with the fill plug hole. Bleed the unit. Replace the filler plug, creating a snug fit. Do not over-tighten.

Jack fails to lower:

1. Look for any bent frame parts (lifting link, push rod, etc.) Bent frame parts need to be replaced.
2. The handle control may be out of adjustment.

Jack lifts in short increments:

1. Lack of oil pressure - check fluid level.
2. Reservoir filler plug leaking - replace the washer and filler plug and replenish oil as necessary.

One fork lifts, the other does not:

Check for damage in the following areas and their attached parts:

1. Lifting link (lifting link pin and traverse shoulder pin)
2. Pushrod
3. Load roller bracket (pivot axle)

Note: 
Always use SP UNI-HO hydraulic oil. Do not use automotive oil or hydraulic brake fluid.

Email or call (800)331-0839 us today for your parts!

Uline H-1043, H-1366, H-1193, H-1484 Parts Support

We now have prepackaged load wheel kits for your Uline Pallet Jacks! These wheel kits contain two load wheels, bearings, axles, and fasteners. Everything you need to replace your load wheels!

Keep your jack rolling with a new set of load wheels.

Did you know...

A pallet jack does not consume oil, even after a few years it won't be necessary to add oil. The only way a pallet jack loses fluid is through broken seals. 

Part # GWK-1043-LW

Load wheel kit

Part # UE H-1043-BK100

Hydraulic unit seal kit

What other replacement parts do you regularly stock?