Pallet Jack Push Rod Installation, Lift-Rite L-50

Now that you've removed the push rod, you're probably wondering how to properly re-install it onto your pallet jack. 

There are installation guidelines below for Lift-Rite models L-50 & L-50 CHEP. Technical advice is free for all our customers.

Installation

With the jack still turned on its side, fasten the eye bolt to the lifting link with pin and secure the pin with roll pins. 

Thread the nut onto the eye bolt with enough room to thread onto the push rod. Thread the push rod onto the eye bolt until it approximately matches the other push rod. 

Assemble the load roller brackets and the load roller onto the push rod. Line up the pivot axle hole on the brackets to the axle hole on the frame. 

Slide the pivot axle through the frame, brackets and exit roller (if there's one). Secure the pivot axle to the frame with roll pin. Tighten the nut on the eye bolt against the push rod. 

Email or call (800)331-0839 today for your replacement parts!

Download Lift-Rite Service Manual